BTS7960B H – bridge, and a high – power motor driver Module Overview: This driver USES Infineon chips BTS7960 composed of high – power drive full H – bridge driver module with thermal over – current protection, the Double BTS7960 H – bridge, driver circuit, with a strong drive and style, effectively isolating the microcontroller and motor driver!43 a High – current The Features: Double BTS7960 large current (A) 43 H bridge driver; 5 v isolate with MCU, and effectively protect the MCU; 5 v power indicator on board; Voltage indication of motor driver output end; Can solder heat sink;
Just need four lines from MCU to driver module (GND. 5 v. The PWM1. PWM2); The isolation chip 5 V power supply (can share with MCU 5 V). Size: 4 * 5 * 1.2 cm; Able to reverse the motor forward, two PWM input frequency up to 25 KHZ. Two heat flow passing through the an error signal output; Isolated chip 5 v power supply (can be Shared with the MCU 5 v), can also use the on – board 5 v supply; The supply voltage of 5.5 V to 27 V.
Package list: BTS7960B motor driver X 1 Sch, PID program sent by Email 5 supports the I2C protocol 6 with backlight power control, can be connected via jumper Settings are backlight power. The plug-in the jumper to connect the backlight off, unplug the jumper to disconnect the backlight power 7 Contrast can be adjusted by turning the blue potentiometer clockwise happens, counterclockwise weakened. The potentiometer design on the front, enabling customers to freely adjust anytime Eight modules can be cascaded to cascade up to eight. By short short-circuiting A0 / A1 / A2 modify the device address. The default address is 0 x27 Shipping list: 1. The IIC module a (EPE + antistatic packaging)