3d printing Tractor Diesel Engine Single Cylinder Internal Combustion Gift Decoration Souvenir Model Oriental Red 3D10

Introduction:

This is the engine of a hand-held tractor printed by 3D printing technology. It can be bought back as a decoration, which is very good.

If you have good hands-on abilities, you can also DIY to make a whole tractor or trolley.

Note: Because it is printed by a 3d printer, there may be burrs or layers in some parts, which are unavoidable.

Main power: high-power 280 motor (if you need to make another car through the reducer, that is, the gearbox)

Power: 7.2-7.4v     18650 lithium battery pack (size just fit in the water tank)(not provide battery)

Note: There is no battery in the delivery! ! !

Air transportation does not send batteries! ! ! B

attery everyone buy 18650 lithium battery SM plug male

Throttle control: Throttle size is achieved by pulling the throttle knob through the steering gear

Simulation point:

1. The appearance is quite like the head of an early Chinese tractor.

2. Must be shaken to reach a certain speed to start.

3. There is a throttle.

4. If the resistance is too large, the speed will be turned off when the speed is lower than a certain value.