RP5 Crawler Chassis Tanks Smart Car Power Tracking Tracing Obstacle Avoidance Driver Module for Arduino

SINONING

$49.00 

Introduction

High-power tank body adopts big torque motor, 280 with a inductance combination + metal bevel gear, form a big torque and low noise chassis system! With high dynamic performance is strong, the chassis stability, flexible circles, turning, etc. Is a very good platform for the embedded control.

The performance parameters

  • Or: 58 mm * 180 mm * 135 mm (length * width * height)

  • Operating voltage: 7.2 V

  • The working current: 160-180 mA

  • Maximum speed: 30 cm/s

  • Climbing ability: > 30 °

  • Payload: > 7.5 Kg

  • Note: the above data is only for reference; Because of difference of battery performance and site, the actual measured values and reference might be different.

Product configuration

  • chassis

  • A battery pack

  • Gear set

  • A pair of 280 motors

  • Form a complete set of motor inductance of a couple

Note

  • Default only provide tank car-body dc motor and reducer, battery holder (section 6). At least more than 3 kg load capacity. Can be more obstacles, especially suitable for the occasion of higher requirements.

  • The above data is only for reference; Because of difference of battery performance and site, the actual measured values and reference might be different.

14398890205838

13890067662635

14398890348426

14398890357396

14398890367940

 

application show

1389006789150

  • You don’t look down on the chassis, pedrail robot has production from 2002, the order has not stopped, new technology:
  • Large torque, weight 7.5 KG turn freely
  • The noise is small.
  • Crawler drive for a long time will not derail!
  • The guest feedback effect is very satisfied!

Personal view

  • Tank chassis adopts dc motor slowdown, large torque, suitable for bearing larger situation, such as circuit board is more and more sensors, with LCD, and so on. Suitable for smart car with relatively complicated functions (robot)
  • Car use 3 v to 5 v dc motor, torque is small, not suitable for important occasions, that is to say, should not be extended many circuits. Due to too many things go up, open. 2-3 batteries (car to add 3-4.5 V power supply to the alternator, plus 3-4 section 4.5 6 V battery to microcontroller IC, such as power supply, battery alone a bit heavy)
  • Remind use rechargeable batteries friends, use must be battery charging together, charging time and same, they use, using the unified brand. Otherwise it will cause the battery internal resistance and power consumption, damage the rechargeable batteries.

Our brands